Mercedes S-Class W-220

since 1998 of release

Repair and car operation

W220 Mercedes
+ Mercedes-Benz Cars of a class S (W220)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Automatic transmission
+ Power shafts
+ Brake system
- Suspension bracket and steering
   Security measures
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Corners of installation of wheels of the car - the general information
      Conditions of check of corners of installation of wheels
      Adjustment of forward wheels
      Adjustment of back wheels
      Check of a road clearance of a body of the car
      Removal and installation of the steering mechanism
      Pump of the amplifier of a steering
      Dismantling and assembly of the pump of the amplifier of a steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the bottom steering shaft
      Removal and drive installation for telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe
      Removal and installation of the blocking cylinder
      Contact spring
+ Body
+ Onboard electric equipment
+ electric equipment Cхемы

Adjustment of forward wheels

Check and adjustment of a convergence of forward wheels

	Models 4MATIC
	Rear-wheel models


Shooters — the Centering of provision of a steering wheel 055 — the Holding device 055b — Fastening	10 — Steering draft 10f — the Lock-nut 030 — the Strut

Adjustment of disorder and longitudinal inclination of an axis of turn of forward wheels – is made by means of an ekstsentrikovy bolt

Ruler for measurement of a convergence of forward wheels


Beissbarth — No. P860 000 883, No. P 872 Matra — No. 002 548 199 074	Bosch — No. 2 688 190 000, No. — 1 688 190 022

Adjustment of disorder is carried out by a forward ekstsentrikovy bolt 19, and the longitudinal tilt angle of an axis of turn of a wheel is regulated by a back ekstsentrikovy bolt 20 on the bottom lever.

Check and adjustment of a convergence of forward wheels

PERFORMANCE ORDER

1. Establish wheels in situation for rectilinear movement by means of the device 055.
2. Check the central position of the steering mechanism and a steering wheel (arrow).
3. Establish a ruler 030 between internal surfaces of forward wheels. Check a convergence of forward wheels.
4. Adjustment of a convergence is carried out by rotation of steering drafts 10.

The convergence of forward wheels is given in Specifications.