Mercedes S-Class W-220

since 1998 of release

Repair and car operation


W220 Mercedes
+ Mercedes-Benz Cars of a class S (W220)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Automatic transmission
+ Power shafts
+ Brake system
- Suspension bracket and steering
   Security measures
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Corners of installation of wheels of the car - the general information
      Conditions of check of corners of installation of wheels
      Adjustment of forward wheels
      Adjustment of back wheels
      Check of a road clearance of a body of the car
      Removal and installation of the steering mechanism
      Pump of the amplifier of a steering
      Dismantling and assembly of the pump of the amplifier of a steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the bottom steering shaft
      Removal and drive installation for telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe
      Removal and installation of the blocking cylinder
      Contact spring
+ Body
+ Onboard electric equipment
+ electric equipment Cхемы




Dismantling and assembly of an internal pipe

Dismantling

 PERFORMANCE ORDER

1. Unscrew a nut 92d and remove a blocking plate 92е. Remove a disk spring 70е and a persistent ring 70d.

2. Take a steering shaft 70g, a persistent ring 70b and a lock ring 70с. Two blocking rings are established on models with a contact spiral. Vypressuyte the ball bearing from a pipe, using a steering shaft, also replace it.


Assembly

 PERFORMANCE ORDER

1. Press the ball bearing 70а in an external pipe 81b against the stop. Insert a steering shaft 70g. Press the second ball bearing 70а.

2. Establish a persistent ring 70b and a lock ring 70с together on a steering shaft 70g. Be convinced that the lock ring 70с is blocked in the necessary situation in a groove of a steering shaft.

3. Establish a persistent ring 70d, a disk spring 70е and a new lock plate 92е fixing ears in the direction to a nut. Wrap a nut 92d and tighten her hand.

4. Check ease of rotation of a steering shaft. The steering shaft should not have axial palpation in a pipe and should rotate without jammings.





home