Mercedes S-Class W-220

since 1998 of release

Repair and car operation


W220 Mercedes
+ Mercedes-Benz Cars of a class S (W220)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Automatic transmission
+ Power shafts
+ Brake system
- Suspension bracket and steering
   Security measures
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Corners of installation of wheels of the car - the general information
      Conditions of check of corners of installation of wheels
      Adjustment of forward wheels
      Adjustment of back wheels
      Check of a road clearance of a body of the car
      Removal and installation of the steering mechanism
      Pump of the amplifier of a steering
      Dismantling and assembly of the pump of the amplifier of a steering
      Dismantling and assembly of an electronic and adjustable steering column
      Removal and installation of the bottom steering shaft
      Removal and drive installation for telescopic adjustment of a steering column
      Removal and installation of an emphasis of a pipe
      Dismantling and assembly of an internal pipe
      Installation of the top arm of fastening of a pipe
      Removal and installation of the blocking cylinder
      Contact spring
+ Body
+ Onboard electric equipment
+ electric equipment Cхемы




Removal and installation of the blocking cylinder

Removal

 PERFORMANCE ORDER

1. Unscrew a guard 36а dashboards by means of a key 020 (models without an immobilizer).

2. Take the L11 coil from the blocking cylinder (model with an immobilizer).
3. Put on the plug 011 a cover 36b and turn the blocking cylinder in situation "1" by means of a key.
4. Disconnect the blocking cylinder cover rotation 36b counter-clockwise on 90 °.


Installation

 PERFORMANCE ORDER

1. Grease an external part of the blocking cylinder 36 with hermetic and insert a cover 36b.
2. Establish a key through a cover 36b in the blocking cylinder 36 against the stop. The groove (shooter) on the blocking cylinder 36 should be combined with a groove on the lock of blocking of a steering shaft (shooter).
3. Establish the blocking cylinder 36 in the lock of blocking of a steering shaft.
4. Turn a cover 36b with the plug 011 clockwise on 90 ° so that it was possible to block it.
5. Turn a key in situation "0" and remove the plug 011.
6. Tighten a guard 36а on the dashboard by means of a key 020 (models without an immobilizer).
7. Press the L11 coil on the blocking cylinder.





home