Mercedes S-Class W-220

1. Remove a power shaft.
2. Remove a brake disk.
3. Remove blocks of lay brake system.

4. Take a flange of a power shaft 10 (at the established support of a wheel).

5. Remove a lock ring 9.
6. Remove the radial and persistent ball bearing 8 of a wheel support.
7. Take an internal ring of the bearing from a flange of a power shaft.

Check axial and radial palpation of a flange 10 power shafts. Admissible axial palpation of a flange - 0.03 mm, radial palpation - 0.03 mm.

Installation is carried out as it should be, the return to removal.

2. Establish a basic plate 010d on a wheel support.

3. Establish a clamping plate 010f with a clamping bolt 010b through an arm and establish again on a basic plate 010d.

4. Establish a hydraulic press 010h between persistent laying 010f and an arm 010g. Unscrew clamping a bolt 010k from a hydraulic press, then a bolt 010i an arm until it will not concern the clamping cylinder of a hydraulic press.

5. Screw clamping a bolt 010k a hydraulic press (the maximum moment of 40 N · м) until the flange of a power shaft will not be removed. Strike with a hammer on an arm (shooter). If it will be insufficiently, turn out a bolt 010i from an arm.

Establish a flange 10 on the dvukhryadny radial and persistent ball bearing 8, using the adjusting tool (08а - 08с, 08е - 08i). Be convinced that the clamping plate (small, 08с) is correctly established on an internal ring of the bearing (shooter).

1. Removal of the dvukhryadny radial and persistent ball bearing is shown on an illustration.
2. Installation of the dvukhryadny radial and persistent ball bearing it is shown on an illustration.