Mercedes S-Class W-220

since 1998 of release

Repair and car operation

W220 Mercedes
+ Mercedes-Benz Cars of a class S (W220)
+ Operation manual
+ Routine maintenance
+ Engine
+ cooling and heating Systems
+ Power supply system and release
+ engine Electric equipment
+ Automatic transmission
- Power shafts
   - Driveshaft
      Removal and driveshaft installation
   + Power shafts
   + Differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Cхемы

Driveshaft

Removal and driveshaft installation

Driveshaft


2 — the Driveshaft 5, 21, 200а — Bolts 6, 20, 36 — Washers 7, 35, 88, 200 — Nuts 18 — an engine Support	19 — an engine Arm 56 — the Epiploon 87 — the Flange

Removal

PERFORMANCE ORDER

1. The driveshaft with connections is presented on an accompanying illustration.
2. Lift a transmission by means of a jack.

3. Unscrew a nut of fastening of a support of the engine 35. Unscrew bolts 21 with washers and remove an engine 19 arm together with a support 18.

4. Unscrew the driveshaft from a transmission. Unscrew a bolt of the 8th fastening of a shaft of a speedometer 9 and remove it.

5. Weaken adjusting plugs in a flange кардана. For this purpose use a drift in diameter of 10 mm and length about 150 mm.

6. Weaken a nut of the driveshaft and move the driveshaft from a flange in the direction to a back part of the car.

7. Unscrew bolts 200a.

Installation

PERFORMANCE ORDER

Installation is made upside-down.

home