Repair and operation of the Mercedes S-Class W-220 c car of 1998 - cooling System//S-class Mercedes / keramicheskoy-plitki.ru

Mercedes S-Class W-220

since 1998 of release

Repair and car operation



W220 Mercedes
+ Mercedes-Benz Cars of a class S (W220)
+ Operation manual
+ Routine maintenance
+ Engine
- Cooling and heating systems
   - Cooling system
      Antifreeze - means of protection from freezing
      Replacement of cooling liquid - general comments
      Removal and replacement of hoses of system of cooling
      Check, thermostat
   + Systems of ventilation, heating and air conditioning
+ Power supply system and release
+ engine Electric equipment
+ Automatic transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Cхемы






Cooling system

General information

Scheme of a contour of system of cooling

1 — the Heater
2 — the Engine
3 — the Thermostat
4 — the Water pump
5 — the Broad tank

6 — the Cover with the valve
7 — the Radiator
8 — Perepuskna a hose
9 — the Oil radiator


Radiator and fan

1 — the Radiator
2 — the Broad tank
3 — the Top hose of a radiator
4 — Nizhny a radiator hose
5 — the Cover of a broad tank

6 — the Water pump
8 — the Thermostat
9 — Krylchatka of the fan
10 — the Damper of krutilny fluctuations


While the engine is not heated-up, cooling liquid circulates only in a head and the block of cylinders and in the heat exchanger of a heater of salon. At increase of temperature of cooling liquid the thermostat opens a big contour of cooling. Cooling liquid goes through a radiator constantly working pump. Liquid passes through a radiator from top to down and is cooled with air passing through it.

Heating and ventilation system

The system of heating consists of fans and the heat exchangers located in blocks of forward and back parts of salon. Hot cooling liquid passes through heat exchangers. When moving the handle of management by modes of the heater, located on the control panel, valves and hot air open starts to arrive in car salon. If to turn on the heater fan, air will move in salon compulsorily.

Intaking air before getting to salon, passes through the filter (address to Head Routine maintenance). The main share of particles of a dust will settle in the filter. It is necessary to observe periodicity of replacement of the filter. The filter blocked by a dust will limit supply of air in salon that will lead to an air stagnation in salon.

Distribution of streams of air of system of ventilation is carried out with the help a zaslonok. The air circulation mode is provided. Zaslonki cope with the help of servo-drivers.